Has anyone any experience of this door operator, with TMS500 controller?

-- Steven Fairclough (wjwtwsmv@tiscali.co.uk), June 27, 2003

Answers

ADC Doors

The answer is yes, but specifics are required. What is your problem? The type of control that the ADC operator is connected too, may be insignificant. Most of the control for this operator is on board. Common fault is a servo pot failure in the main door drive pulley, causing trip outs, due to loss of position information. What is your problem? Do you have any set-up information for these doors? You will need it!

-- jon (Jon1701@yahoo.com), June 27, 2003.