Hydro noisegreenspun.com : LUSENET : Elevator Problem Discussion : One Thread |
I have two Hydros 3 stops 150 FPM with 2 in pipe, freeman mufflers, machine room 1 floor below lowest landing. Pipe run about the same. One has a Blain valve the other was changed and has a Maxton valve Same Cap. Same elevator but for the valve. Ouestion is the one with the Blain valve is very loud when riding the car you can here the oil in the hoistway like you were in the Machine room? Is it the valve?
-- Steve (manupdown@aol.com), October 09, 1999
Steve, what is the pump output (GPM) here?Or, what is the diameter of the plunger?
Is the pipe schedule 40? 80? 120?
Noise in the up, down, both?
Identical cars?
John Brannon
-- John Brannon (akaelevman@ASOL.com), October 10, 1999.
Steve, what is the pump output (GPM) here?Or, what is the diameter of the plunger?
Is the pipe schedule 40? 80? 120?
Noise in the up, down, both?
Identical cars?
John Brannon
-- John Brannon (akaelevman@AOL.com), October 10, 1999.
John, Piston 5 inPipe 40
Noise both directions
Identical cars except for the valve
-- Steve (manupdown@aol.com), October 11, 1999.
Hi Steve,Is the electrical gutter near any part of the piping/if so that will act like a speaker especially if its touching any part of the hydro system,,,good luck...dan
-- Dan Wiegand (Danotis@aol.com), March 10, 2003.