Diagnostic software for Dover T4 & DMCgreenspun.com : LUSENET : Elevator Problem Discussion : One Thread |
Can any tell me of where I can obtain FULL DIAGNOSTIC software for the Dover T4 and DMC units. We have a laptop with purchased software yet it is very limited in its capabilities. Is such a product available? ThanksRay Lancon Field Supervisor @ Emory University Schindler Elevator Company
-- Ray Lancon (ray.lancon@juno.com), January 29, 1998
If your software is limited you need to have the building owner buy the office version for th t-4 ....as for the dmc ther is only one set of diagnostic software and that is used with the fast toolthe t-4 programs are protected by a locking key you have to plug into a printer port... and the dmc uses a hand held tool
the owner of the elevator can obtain the required software from dover elevator but its gonna be expensive
-- j (jaycee8914@aol.com), March 21, 1998.
Ray, you can buy World Elevators : Freedom Tool Software . It will allow you to access all DMC units. As far as I know, they don't have a module for the T-4 yet.
-- Kaz (ratle19-2@idt.net), April 27, 1998.
RAY I USE THE WORLD ELECTRONICS FREEDOM TOOL VERSION 3.2 IT WORKS PREATY GOOD AND HAVE BEEN ABLE TO KEEP MY UNITS UP AND RUNNING WITH THIS SOFTWARE.IT DOES TAKE A KEY IN THE PRINTER PORT TO WORK AND MAN ARE THEY PROUD OF IT COST $ 2,000 EACH .
-- RICHARD (the4gals1@home.com), March 08, 2001.
Our tool is in use for the Dover, Swift and Millar systems Check our web site www.bartelevatorservice.com
-- John Bartolomeo (bartelevator@yahoo.com), March 25, 2003.
I want to CRack the freedom Tool anyone know something about that, i hate the dongles!!
-- Ian Blake (ian_blake_iii@hotmail.com), November 02, 2003.