Do F4 1000 Bars fit 750 F4 - to save my poor thumbs?greenspun.com : LUSENET : MV Agusta F4 : One Thread |
Any idea if the 1000 F4 handle bars fit the 750 F4 - I have heard these don't trap thumbs like the 750. Or is there another way?I recall some carbon air tube covers might work but does the std bike need modifying for these. Or are there any bar-risers alternate handle bars that work on the f4 that are available in UK?
Regards
Mark
-- Mark Holyoake (mholyoake@ukf.net), August 08, 2004
Casoli makes air tubes with cut outs.
-- Brett (DocBDH@aol.com), August 08, 2004.
Mark. fast-by-ferracci make riser kits that are supposed to help. Go to their site and look under race accessories/ clip ons.
-- paul thompson (paulvt1@blueyonder.co.uk), August 09, 2004.
Mark, 1000 bars will fit the 750, however I have just "stripped" my bike of all it`s goodies prior P/Xing it and I have a set of Ferracci riser clamps that I won`t need any more, where abouts in the UK are you?
-- mike (miketilston@btinternet.com), August 09, 2004.
This is what I did to my Evo3 F4 to get the bars higher. Easy just swap the original clip on clamps from left to right and vice versa brings the bars up a treat. Need to remove the locating pins for the brake and clutch levers to get them sitting right also need to redrill a hole in the right side handle bar to relocate the throttle twist grip. Once in place it is a good idea to loosen, reposition and retighten the clutch and brake lines where they exit from their master cylinders to get a more suitable run for the lines.
-- Richard Bridgwater (richard@perfab.com.au), September 09, 2004.