MRC Decoder Programming : LUSENET : Wiring for DCC : One Thread

I have 3 MRC decoders with MRC 2000 I programmed them with step 2 as per instructions ok,but when I tried to program for my walkaround trottle I can't get them to work with any address.Is there a way to reset them?They are the plug in type so they can't be wired wrong.MRC instructions are very vague.

-- Dennis DeBalfo (, December 22, 2001


I have found that if you are trying to program for address 7-10 for some reason you can not use the walk-around to program those addresses. Unplug the walk-around and program 7-10 off of the main board. At least mine seems to have that problem.

-- Doug Kill (, November 10, 2002.

Moderation questions? read the FAQ