Model Layoutsgreenspun.com : LUSENET : Southern Railway : One Thread
I'm considering building one of the layouts contained in the Atlas Introduction to N Scale Model Railroading. In fact, it's the last one in the book. This plan has a maximum of 11' curves and a minimum of 9 3/4. I've been told that running anything like a 2-8-2 would look too "toy like". My questions, then, are these:
How would a 2-8-0 and 4-6-0 look here? Did Southern run on double main lines around 1905 - 1910? Were there any double mains during this time? (My ignorance in railroading is now showing).
This is my first layout and I'd sure like to be able to run two trains if possible, but in the most realistic setting as possible.
Thanks in advance for your input.
-- John B. Hill (firstname.lastname@example.org), December 17, 2001
The Southern Railway had double tracks on its main line between Washington and Atlanta at an early age. I believe that much of the Cincinnati to Chattanooga line was also double track in the early years. A 2-8-0, 4-6-0, 4-4-2 or perhaps a small 4-6-2 would be appropriate power for the 1905-1910 period.
Even where a railroad used a single track main, there would be double track passing sidings that are long compared to the size of a typical model railroad... so go ahead and use double track.
I've seen a somewhat limited selection of locomotives and rolling stock for 1905-1910 in N scale. If this proves to be a problem, one option would be to use four axle diesels. F units and GP units will handle these radii with ease. Stick to 40' freight cars and you should have no trouble. This would be very appropriate for the late 1940s and early 1950s.
Good luck with your layout!
-- Tom Warne (email@example.com), January 09, 2002.