Forte Polywarmtone and Viradongreenspun.com : LUSENET : B&W Photo - Printing & Finishing : One Thread |
Hi Everyone,Does anybody have any experience with this combination? Or any experience with Viradon they would like to share?
Thanks in advance,
-- Kevin Kemner (kkemner@tatesnyderkimsey.com), November 27, 2001
Viradon smells a lot, but is very easy to use as a one bath toner. It works best with chlorobromide papers, warm tone papers, and not at all with some bromide papers.
-- Patric (jenspatric@mail.bip.net), November 27, 2001.
Somewhere or other I read the Viradon tones _more_ with higher dilution, contrary to what logic may indicate. Also, you have to use the HCA afterbath to make it stop toning.I've used Viradon a couple of times with Ilford Warmtone; it toned too yellow/red for me...plus it stank.
-- John Hicks (jbh@magicnet.net), November 27, 2001.
Viradon stinks a bit. Plus, the tone is not controllable except by removing the print halfway through the toning process. I prefer a two step toning process like the bleach and redevelop which is done with most sulfide / sepia toners like Tetenal and Fotospeed. There is much more control, and I like the deep chocolatey browns they can deliver. Added bonus - they dont stink.
-- Vincent (nospam@hotmail.com), November 28, 2001.
Viradon is a beautiful toner. I especially like it with the Forte warm tone papers. My only complaint is the white slime that seems to collect on the surface of the print. After giving the print a bath in 10% sodium sulfite to prevent post toning, I usually take a soft sponge and clean it off while in the wash tray. This usually works but it's a pain. I've been using Kodak brown toner recently and the results are similar only without the slime. Give it a try...its easy and it's cheap.
-- Walter Massa (WFMassa@webtv.net), November 29, 2001.