uneven toning with sulfidegreenspun.com : LUSENET : B&W Photo - Printing & Finishing : One Thread |
I have a problem: some of my sulfide toned prints came out enevenly toned; why? Is it a problem with the bleach bath or the sulfide bath?
-- xosni (xosni@gega.net), February 23, 2001
I haven't had a problem with this unless the prints were fixed with hardner...
-- Scott Walton (f64sw@hotmail.com), February 23, 2001.
No it wasn't a hardening fixer that i used.
-- xosni (xosni@gega.net), February 23, 2001.
I've only done a little sepia toning in class, but our instructor said you can get bad stains if the prints are not properly fixed and washed before toning.
-- Bill A. (bill.akstens@trw.com), February 23, 2001.
I've had this problems too. The problem can be small bubbles on the paper. You can use rubber gloves and give the paper a few strokes with your hand. Remember to agitate the bath a lot.
-- Patric (jenspatric@mail.bip.net), February 23, 2001.
It's uneven bleaching. I know it now!
-- Xosni@gega.net (xosni@gega.net), February 24, 2001.