Audio capture problem

greenspun.com : LUSENET : Video CD : One Thread

I am getting an error message that says that the program cannot connect to the audio device. I am using a belkin USB videobus II and MGI videowave 3. The drivers seem to be installed properly but I can't get any audio to come in. Do you have any suggestions?

-- Bryce Cronkleton (cronkleton@yahoo.com), January 09, 2001

Answers

Don't know if this applies but, on my system, I have to open the television software application that comes with my capture device, verify I have sound, close it, and finally open any third party capture software. Go figure?

Also, if I try to capture with too much compression, I'll get just that same message as you have.

Can you capture OK raw?

-- me (snake_mountain@hotmail.com), January 10, 2001.


I had the same problem. Changed the audio selection to videobus audio from videobus 16 and it worked.

-- Jim (solinski@email.com), January 30, 2003.

Moderation questions? read the FAQ